This is the output of serial port (/dev/ttyUSB0) after pressing RST button:
ets Jul 29 2019 12:21:46
rst:0x1 (POWERON_RESET),boot:0x1f (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DOUT, clock div:2
load:0x3fff0018,len:4
load:0x3fff001c,len:6792
load:0x40078000,len:12072
load:0x40080400,len:6708
entry 0x40080778
I (75) boot: Chip Revision: 3
I (75) boot_comm: chip revision: 3, min. bootloader chip revision: 0
I (40) boot: ESP-IDF v3.3.2-107-g722043f73-dirty 2nd stage bootloader
I (40) boot: compile time 11:08:03
I (41) boot: Enabling RNG early entropy source...
I (46) boot: SPI Speed : 40MHz
I (51) boot: SPI Mode : DOUT
I (55) boot: SPI Flash Size : 4MB
I (59) boot: Partition Table:
I (62) boot: ## Label Usage Type ST Offset Length
I (70) boot: 0 nvs WiFi data 01 02 00009000 00006000
I (77) boot: 1 phy_init RF data 01 01 0000f000 00001000
I (85) boot: 2 factory factory app 00 00 00010000 00100000
I (92) boot: End of partition table
I (96) boot_comm: chip revision: 3, min. application chip revision: 0
I (103) esp_image: segment 0: paddr=0x00010020 vaddr=0x3f400020 size=0x1f670 (1p
I (159) esp_image: segment 1: paddr=0x0002f698 vaddr=0x3ffb0000 size=0x00978 ( d
I (160) esp_image: segment 2: paddr=0x00030018 vaddr=0x400d0018 size=0x22788 (1p
I (217) esp_image: segment 3: paddr=0x000527a8 vaddr=0x3ffb0978 size=0x014f8 ( d
I (220) esp_image: segment 4: paddr=0x00053ca8 vaddr=0x40080000 size=0x00400 ( d
I (224) esp_image: segment 5: paddr=0x000540b0 vaddr=0x40080400 size=0x0a190 ( d
I (257) boot: Loaded app from partition at offset 0x10000
I (257) boot: Disabling RNG early entropy source...
################################################
arch:ESP32, 3
compile_time:Ai-Thinker|B&T
ble_mac:b8D61A59XXXX
wifi_mac:b8D61A59XXXX
sdk_version:v3.3.2-107-g722043f73-dirty
firmware_version: v1.1.0
compile_time:Jun 8 2021 11:08:16
################################################